Beginners Guide

Well OK, it’s a honing guide if I have to be honest. But I am a beginner, so…

I bought a plane to go with my chisels. Not the aircraft type. When I told my good lady I had bought one, she nearly had a fit. She works with aeroplanes. An air traffic controller. She’s easily confused. Well, she is around me. I’m not always clear about what comes out of my mouth…

Anyhow, here it is. An Irwin Record no. 4. A smoothing plane. Probably one of the most popular models in the world.

Like the chisels, one would expect it to be ready to go when it comes out of the box. Just like the chisels, no it isn’t. It’s all there, but it isn’t really sharp yet and although it will take a shaving off the wood the result is not exactly pretty or smooth.

Stripping the thing is a doddle. One removes the locking plate on the front of the plane and the blade falls out nicely into your hand. The blade is bolted solidly to the chip breaker and needs to be freed from that. Again, that’s easy. So, finally, one is left holding the business part of it all. The blade. 50 mm broad and not blunt by any means. Just not yet sharp enough for the job it is intended to do.

Sharpening this blade is similar to sharpening a chisel. The back of the blade has to be dead flat and the bevel, on the reverse side, equally flat. The two should meet at 30° all along the edge.
Now, my fingers are strong enough to steer a chisel on the grinding surface but not for a 50mm broad piece of steel. I know I’d get it out of square and render it useless as a cutting instrument. There are things that are made to help with this. Hence the purchase of the honing guide. A lovely little piece of kit designed to hold the blade in a set of mini-jaws and a wheel on the other side to enable one to push it backward and forward over the abrasive surface. The protruding blade is set to hold the required angle on the abrasive. For my purposes, that protrusion is 37 mm with the guide that I have.

The one pictured here is upside down as we look at it. I don’t know why but I couldn’t find a picture of one the right way up.

This one will also take chisels as well as plane blades. Handy, I thought. Two birds, one stone. What’s not to like?
I had to try it. Off to the I-Shed then. (I built the shed, so it’s an I-Shed. OK? Screw Apple.)
I stripped the plane and polished the back of the blade on my plate glass and the abrasive paper. It polished up nicely, flat to the edge. Then on to the bevel. I took the guide, fitted the blade, measured the length and got back to the abrasive. Heave-ho and run the thing over the wet and dry 500 grit for about two minutes. Soon, I had an edge. I then went for 1000 grit and really polished it up.

After about ten minutes work I reassembled the plane, took a piece of scrap wood and set it in the vice. A deep breath and push. Whooosh!
Curly shavings all over the place! Hosanna! The thing works.

It’s not often one buys something cheap and cheerful from China that actually does what it says it should. This thing worked a treat. Even if I did have to wait for a month for delivery.

How does one say ‘thank you’ in mandarin?